Electronics

Slows down the 'speed' of any RC servo, while retaining the maximum servo output torque. Independently adjust end-to-end speed in each direction, from 0.5 sec to more than 10 sec.
E-Z set-up!
Plug-and-Play installation, with universal connectors.

NOW with Built-in Pro Servo Reverser for SUPER convenience with flaps, spoilers, etc.

• Manages Retracts, Steering and Brake
• Frees up Steering and Brake channels on the radio
No complicated Tx mixing
• Saves up to 4 mixes!
• Prevents accidental gear collapse on power-up

Bench-test turbine (or other - Gas/Glow/Electric) engines without a transmitter or receiver!

Features:
• Up to 2 channels
  • Manual Sliders - Throttle with Trim
  • Run Mode - 3-position toggle switch
• Power switch
• Channel Reversing
• Requires 4.8V - 7.4V (NiCd / NiMH, A123, LiFe, LiPo) Battery
• Compatible with Futaba, JR, Hitec, Airtronics servos, ECU's, ESC's

Forgot to switch off the Rx after landing or when leaving the field... and ran the batteries flat?!!

We've all done it.

Save your batteries!  The  EDR-117PI "Forget-Me-Not" Power Indicator's BRIGHT Sunlight-Visible Lamp will remind you that the Rx is ON.

Installation's a snap!

• Just mount the EDR-117PI into a 1/4" dia. hole and plug it into a spare channel on your Rx. How E-Z is that??
• No spare channels?
  No problem. Simply share a channel (e.g., throttle) thru a Y-harness.  

The EDR-117PI works with 4.8V - 7.4V {NiCd/NiMH, ED-Nano (A123)}, Lipo 2s batteries, uses less than 40mA, and its Piercing BRIGHT White light  is clearly visible at more than 50 feet, in sunlight!

Simple.  No-Hassle.  Never forget to switch off again!

Save $4.00! Order it with one of our Ultra-Switch II's

12-inch JR Male-to-Male Extension / Battery Tap. Connects receivers to devices like:

• Battery Tap for our EDR-117RCP LiteSys Controller
• Turbine ECU's