CellPro10S Charger
$189.95
FMACP10S
FMA CellPro 10S A123-compatible Charger
Advanced Lithium Charger with Full-Power Balancing Technology
Safe and E-Z, "No-hassle" Charging of ED-Nano (A123) Batteries from 1S (3.3V) to 10S (33.0V) in minutes with adjustable charge current up to 10 Amps.
The CellPro 10S is the next level up from the CellPro 4S for those who want higher charging current (faster charge) with Heavy-Duty Batteries. It has all the features of its more economical CellPro 4S, with these additional features:
- Up to 10A Max Charge Current
- Continuous Power 300W (estimate)
- Displays Individual Cell Internal Resistance to 0.1 mohm Resolution
(Battery Quality Indicator, a feature exclusive to the Cellpro 10s charger)
- Charges Lithium Polymer or A123 Cells (variable charge rates for both LiPo
and A123 cells). Charges 1 Pack of 1s-10s or 2 Packs of 1s-5s Simultaneously
- Includes Start/Stop Button
- Backlit Liquid Crystal Display
- Supports 2-way P.C. Interface
- Drive the Charger from the P.C.
- Access Advanced Features from the P.C. (Setup Custom Presets, Adjust
Speaker Volume, LCD Contrast, and More)
- Internet Upgradability (IU) Feature -- No need to send the charger to the
factory for firmware upgrades again. Do it over the internet.
The Cellpro 10s charger may be used to charge any brand of Lithium pack using
either the Cellpro adapters or pigtails. The charger includes two 5s output
connectors and includes two simple 5s-to-4s adapters. This enables automatic
support for any current Cellpro 2s-4s battery sold in the past. These extra
accessories also enable you to connect any of the existing Cellpro 4s adapters
for other brand batteries with the Cellpro 10s charger.
Using the Cellpro 10s Charge Control Software, the charger can be set to work
with virtually any good, regulated power supply, even if the power supply is not
designed for high power. By entering current capability; e.g., 1-25A, the
charger will automatically adjust the maximum charge current to protect the
programmed power supply. There is also a simple procedure that can be performed
at the field to reset the input power supply to the factory default (25A) if a
PC is not available. You might need to do this, if for example, you use a small
AC power supply at home, but you want full charge current from your car battery
at the field. This powerful feature allows you to decide how much money to spend
on your power supply.
FMA’s Cellpro Node Connector is a key part of the system. It enables the
charger to monitor individual cells and independently charge each cell to its
optimum level.
You'll need a JR Balance Adapter if charging our EDN-2S1P packs.
|
|
|
Quantity
|
